Changes

m
no edit summary
Line 1: Line 1: −
''Indication'' is configurable in configurator ''User Interface'' tab or via [[FMB Device Family Parameter list|SMS/GPRS parameter ID]]. Each 100 ms device checks if any indication is enabled and triggered. If indication is triggered, then FW starts indicating. If two scenarios need to indicate on the same indication source (''LED'' or ''Vibration'') then the active indication scenario needs to finish indicating first. An example of indication configuration is shown in the picture below. When ''Period'' is set to 0, then indication will start immediately to indicate with configured LED and use vibration, if it is enabled. Period only works for ''Periodic'' scenarios (refer to the table below). Indication will turn on ''LED'' and ''Vibration'' for configured ''On'' time and then keep them off for a configured ''Off'' period. When configured ''Repeat'' value is higher than 0 the device continues On/Off cycle. If indication is periodic and ''On'' parameter value is set to 0, then LED and vibro will be set ON and will be set OFF only when indication will be canceled. Only Alarm and Power Key Pressed, Device Off indications can take over control of that LED and Vibro.  
+
''Indication'' is configurable in ''User Interface'' tab of configurator or via [[FMB Device Family Parameter list|SMS/GPRS parameter ID]]. Each 100 ms device checks if any indication is enabled in response to triggered scenarios. If two scenarios need to indicate on the same indication source (''LED'' or ''Vibration'') then the active indicating scenario needs to be finished first (with exception of ''Alarm'', ''Power Key Pressed'' and ''Device Off'' scenarios, which can override control of indication sources). An example of indication configuration is given in the picture shown below. ''Period'' setting is indicative of ''Periodic'' scenarios (refer to the table below) and if ''Period'' is set to 0 the indication will take place immediately. If indication is periodic and ''On'' parameter value is set to 0, then the indication source will stay on until the scenario is finished. Triggered scenarios will turn on ''LED'' and/or ''Vibration'' for a configured ''On'' duration and then keep them off for a configured ''Off'' period of time. In case the configured ''Repeat'' value is higher than 0 the device continues On/Off cycle.
     

Navigation menu