Changes

27 bytes removed ,  09:51, 19 February 2020
no edit summary
Line 1: Line 1:  
''Indication'' is configurable in ''User Interface'' tab of configurator or via '''SMS/GPRS parameter ID'''. Each 100 ms device checks if any indication is enabled in response to triggered scenarios. If two scenarios need to indicate on the same indication source (''LED'' or ''Vibration'') then the active indicating scenario needs to be finished first (with exception of ''Alarm'', ''Power Key Pressed'' and ''Device Off'' scenarios, which can override the control of indication sources). An example of indication configuration is given in the picture shown below. ''Period'' setting is indicative of ''Periodic'' scenarios (refer to the table below) and if ''Period'' is set to 0 the indication will take place immediately. When indication is periodic and ''On'' parameter value is set to 0, the indication source will stay on until the scenario is finished. Triggered scenarios will turn on ''LED'' and/or ''Vibration'' for a configured ''On'' duration and then keep them off for a configured ''Off'' period of time. In case the configured ''Repeat'' value is higher than 0 the device continues a periodic on/off cycle.
 
''Indication'' is configurable in ''User Interface'' tab of configurator or via '''SMS/GPRS parameter ID'''. Each 100 ms device checks if any indication is enabled in response to triggered scenarios. If two scenarios need to indicate on the same indication source (''LED'' or ''Vibration'') then the active indicating scenario needs to be finished first (with exception of ''Alarm'', ''Power Key Pressed'' and ''Device Off'' scenarios, which can override the control of indication sources). An example of indication configuration is given in the picture shown below. ''Period'' setting is indicative of ''Periodic'' scenarios (refer to the table below) and if ''Period'' is set to 0 the indication will take place immediately. When indication is periodic and ''On'' parameter value is set to 0, the indication source will stay on until the scenario is finished. Triggered scenarios will turn on ''LED'' and/or ''Vibration'' for a configured ''On'' duration and then keep them off for a configured ''Off'' period of time. In case the configured ''Repeat'' value is higher than 0 the device continues a periodic on/off cycle.
   −
[[Category:TMT250 Manual]]
   
[[Image:Tmt250_user_interface.png|800px|none]]
 
[[Image:Tmt250_user_interface.png|800px|none]]
  

Navigation menu