Trip/Odometer settings

From Wiki Knowledge Base | Teltonika Mobility
Electric Mobility > TST100 > TST100 Configuration > Trip/Odometer settings

Trip Settings

Trip section offers user to configure the Trip feature. Trip starts when Ignition according Ignition source is ON and Movement according Movement source is ON and also 'Start Speed' is exceeded. Start Speed defines the minimum GPS speed in order to detect Trip start. Ignition OFF Timeout is the timeout value to detect Trip end once the Ignition (configured ignition source) is off. I/O Trip Odometer must be enabled to use Distance counting mode feature. When it is set to Continuous, Trip distance is going to be counted continuously (from Trip start to Trip end) and written to I/O Trip Odometer value field. When Trip is over and the next Trip begins, Trip Odometer value is reset to zero. When Mode is set to Between Records, the distance is going to be counted between every record made. This value is written to I/O Trip Odometer value field and is reset to zero every new record until the Trip ends. If later all Odometer values are summed up manually, the distance driven during the whole duration of the Trip can be obtained.

TST100 trip settings.png

Odometer

Calculation Source allows to choose Odometer calculation source between GNSS, or Scooter. Odometer Value sets the starting total odometer value.

OdometerODM.png