TMT250 User interface
Indication is configurable in configurator User Interface tab or via SMS/GPRS parameter ID. Each 100 ms device checks if any indication is enabled and triggered. If indication is triggered, then FW starts indicating. If two scenarios need to indicate on the same indication source (LED or Vibration) then the active indication scenario needs to finish indicating first. An example of indication configuration is shown in the picture below. When Period is set to 0, then indication will start immediately to indicate with configured LED and use vibration, if it is enabled. Period only works for Periodic scenarios (refer to the table below). Indication will turn on LED and Vibration for configured On time and then keep them off for a configured Off period. When configured Repeat value is higher than 0 the device continues On/Off cycle. If indication is periodic and On parameter value is set to 0, then LED and vibro will be set ON and will be set OFF only when indication will be canceled. Only Alarm and Power Key Pressed, Device Off indications can take over control of that LED and Vibro.
| Name | Type | Trigger |
|---|---|---|
| GSM Error | Periodic | When SIM not inserted, is blocked, failed to connect to operator or jammed |
| GSM Registering | Periodic | When trying to register to GSM network |
| SMS Send/Received | One Off | When SMS is received or sent |
| Outgoing Call | Periodic | When outgoing call is in process |
| Remote Connection | Periodic | When device is connected to server |
| Event | One Off | When eventual record is saved |
| Panic Event | One Off | When panic record is saved |
| No GPS Fix | Periodic | When device searches valid GPS fix |
| GPS Fix | Periodic | When device has valid GPS fix |
| Device Off | One Off | When device is turning off |
| Device On | One Off | When device turns on |
| Power Key Pressed | Periodic | When alarm button is pressed and hold |
| Power Key Pressed | Periodic | When power button is pressed and hold |
| Function Activated | One Off | Button was triggered with configured function to activate functionality |
| Function Deactivated | One Off | Button was triggered with configured function to deactivate functionality |
| Charging | Periodic | When device is charging |
| Fully Charged | Periodic | When device is fully charged |
| Pre Alarm | Periodic | When ManDown functionality starts counting timeout til event |
| Sleep Mode | Periodic | When device is in sleep mode |
| I Am Alive | Periodic | When configured period passes |
